Struct esp_idf_hal::sys::touch_filter_config

#[repr(C)]
pub struct touch_filter_config {
    pub mode: u32,
    pub debounce_cnt: u32,
    pub noise_thr: u32,
    pub jitter_step: u32,
    pub smh_lvl: u32,
}

Touch sensor filter configuration

Fields

mode: u32

<Set filter mode. The input of the filter is the raw value of touch reading, and the output of the filter is involved in the judgment of the touch state.

debounce_cnt: u32

<Set debounce count, such as n. If the measured values continue to exceed the threshold for n+1 times, the touch sensor state changes. Range: 0 ~ 7

noise_thr: u32

<Noise threshold coefficient. Higher = More noise resistance. The actual noise should be less than (noise coefficient * touch threshold). Range: 0 ~ 3. The coefficient is 0: 4/8; 1: 3/8; 2: 2/8; 3: 1;

jitter_step: u32

<Set jitter filter step size. Range: 0 ~ 15

smh_lvl: u32

<Level of filter applied on the original data against large noise interference.

Trait Implementations

impl Clone for touch_filter_config

fn clone(&self) -> touch_filter_config

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for touch_filter_config

fn fmt(&self, f: &mut Formatter<'_>) -> Result<(), Error>

Formats the value using the given formatter.

impl Default for touch_filter_config

fn default() -> touch_filter_config

Returns the “default value” for a type.

impl Copy for touch_filter_config