Struct esp_idf_sys::spi_slave_interface_config_t

#[repr(C)]
pub struct spi_slave_interface_config_t {
    pub spics_io_num: c_int,
    pub flags: u32,
    pub queue_size: c_int,
    pub mode: u8,
    pub post_setup_cb: slave_transaction_cb_t,
    pub post_trans_cb: slave_transaction_cb_t,
}

@brief This is a configuration for a SPI host acting as a slave device.

Fields

spics_io_num: c_int

< CS GPIO pin for this device

flags: u32

< Bitwise OR of SPI_SLAVE_* flags

queue_size: c_int

< Transaction queue size. This sets how many transactions can be ‘in the air’ (queued using spi_slave_queue_trans but not yet finished using spi_slave_get_trans_result) at the same time

mode: u8

< SPI mode, representing a pair of (CPOL, CPHA) configuration:

• 0: (0, 0)
• 1: (0, 1)
• 2: (1, 0)
• 3: (1, 1)

post_setup_cb: slave_transaction_cb_t

< Callback called after the SPI registers are loaded with new data.

This callback is called within interrupt context should be in IRAM for best performance, see “Transferring Speed” section in the SPI Master documentation for full details. If not, the callback may crash during flash operation when the driver is initialized with ESP_INTR_FLAG_IRAM.

post_trans_cb: slave_transaction_cb_t

< Callback called after a transaction is done.

This callback is called within interrupt context should be in IRAM for best performance, see “Transferring Speed” section in the SPI Master documentation for full details. If not, the callback may crash during flash operation when the driver is initialized with ESP_INTR_FLAG_IRAM.

Trait Implementations

impl Clone for spi_slave_interface_config_t

fn clone(&self) -> spi_slave_interface_config_t

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for spi_slave_interface_config_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for spi_slave_interface_config_t

fn default() -> spi_slave_interface_config_t

Returns the “default value” for a type.

impl Copy for spi_slave_interface_config_t